Pentair Flotec Omnia 80/5 Manuel D'utilisation Et D'entretien page 11

CHAPTER 3
INSTALLATION
DANGER - ELECTRIC SHOCK RISK
When installing, please ensure electropump is disconnected from electrical supply. Pumps in this
series are not suitable for use in a swimming pool and the relevant cleaning and servicing operations.
DANGER
This appliance can be used by children aged 8 years or over and by persons with limited physical, sensory
or intellectual capabilities, or with limited experience and knowledge, provided that they are supervised or
have been instructed in the safe use of the appliance and are aware of the dangers involved. Children must
not be allowed to play with the appliance. Cleaning and user maintenance must not be carried out by children
unless they are supervised
WARNING
Pollution of the liquid could occur due to the leakage of lubricants
Please use handlebar to remove or lift pump up.
Please use a non-return valve in case pump is connected to fixed installation with rigid piping; this will avoid liquid
circulating when pump has been turned off; use of a pipe fitting will allow easy disconnection of pump for mainte-
nance. Dimensions of drain well must allow max. 30 on/off cycles/hour. ( See USE AND HIS LIMITATIONS )
Please use flexible pipe connected to pump by means of plastic fitting in case of temporary use of pump.
Use a rope to immerse pump and fasten it to pump's handlebar.
OMNIA aut is equipped with a pre-rated float switch ( See Pict. 1 ); please increase or decrease the free piece of float
switch cable by making it sliding through the proper seat on the handlebar, when modifying the rating of float switch.
Pumps used besides garden ponds or similar places may have special requirements.
WARNING
Verify that the floating switch stops the pump as soon as the minimum level is reached.
WARNING
Make sure that the floating switch is free to move. (see also Fig. 7 and 8)
The pumps used in ponds, small lakes, fountains or similar installations or close to them should have a cut-out
switch. Contact a specialised electrician.
PUMP ANCHORAGE
Use the slots on the filter cap (see Fig. 2, pos. 1) to anchor the pump. Then, remove the inserts from the filter cap. It
is also possible to insert 3 screws in the widest section of the slots (see Fig. 2, pos. 2) and turn the filter cap counter-
clockwise so that the screws keep the cap in place in the narrowest section of the slots (Fig. 2, pos. 3). After fixing
the filter cap, it is necessary to insert the pump in the related guides (see Fig. 3, pos. 4) and turn it counterclockwise
to fix it in place (Fig. 5).
USE AND MAINTENANCE MANUAL
EN
9