Maintenance And Cleaning; Technical Data - Vortice MICROCOMFORT T Notice D'emploi Et D'entretien

ENGLISH

Maintenance and cleaning

Before cleaning, be sure to turn off the power and unplug the power plug, or else it may cause electric shock.
1. Clean the surface of the heater with a damp cloth (or moistened with detergent). Do not use gasoline, thinner,
or corrosive detergent or solvent. Do not rinse with water.
2. If too much foreign matter adheres to the filter screen, it will affect the air blowing, so it should be cleaned at
least every other month.
n Do not use chemicals for cleaning.
n Remove the filters in order (below)
n
Filter cleaning: Immerse the filter in cleaning agent for a few minutes and then wash and dry it.
n
Install the filter properly.
●Body surface cleaning
1. Wipe the surface of the heater with a damp cloth. Do not rinse directly with water.
2. Do not use corrosive detergents or solvents for cleaning.
3. Before cleaning the heater, be sure to turn off the power switch and unplug the power cord, or else it may
cause electric shock.
●Maintenance
1. If the product won't be used for a long time, pull out the power plug, pack the heater and prevent dust from
entering.
2. Before packing, make sure that the outer surface and the filter are dry.
3. After packaging, it should be stored in a dry and ventilated place.
Technical parameters
Model
Rated voltage
Rated frequency
Rated power
Net weight
Gross weight
Noise
Executive standards
MICROCOMFORT T - 70872
220-240V
50Hz
1500W +5%/10%
2.2kg
2.8kg
≤55dB
IEC/EN 60335-1;
IEC/EN 60335-2-30; IEC/EN 60335-2-43;
EN 62233; EN 55014-1; EN 55014-2;