Vortice MICROCOMFORT T Notice D'emploi Et D'entretien page 22

ENGLISH
Install the rubber plug and screwç
a) Drill two holes in the wall, and make the diameter of hole as 6mm, depth as 29mm. The distance between
two holes is 74mm.
b) Fix the rubber plug into the two holes.
c) Fix the screws into the above rubber plugs, and screw up its.
Wall hook Rubber plug
29 mm
2X6Ø holes , depth 29mm
Install directly on the wall (no support plate):
a) First screw two rubber plugs into the wall and keep the distance between the two plugs at 148mm;
b) Then attach two screws into the rubber plugs. The distance from the screws to the wall should be 10mm to
ensure sufficient space;
10 mm
2X6Ø holes , depth 29mm
Install the tower rail
1.First insert the left / right bracket with the towel rack into the holes on the left and right sides of the product.
The towel rack is tilted upward at this moment (The initial position is shown in the figure below. The indicated
ribs on the left/right bracket correspond to the horizontal ribs on the middle frame.)
2. Press the towel rack down and turn it to the corresponding position. (The end position is as shown in the figure
below. The indicator ribs on the left/right bracket correspond to the vertical ribs on the middle frame.)
22