Trimming A Beard - SilverCrest SHBS 3.7 A1 Mode D'emploi

BB.5$ B%ERRN 6HLWH  0LWWZRFK  'H]HPEHU    

6.4 Trimming a beard

Beard trimmer attachment|13
NOTE: please note that the cutting lengths will only be
achieved if the switch for cutting length fine tuning|6 is at po-
sition 1 and the hair and beard trimmer|5 is held at a right an-
gle to the skin surface.
• Comb the beard in the direction that it grows.
• Trim the beard downwards from ear to chin. First trim one
side, then the other.
• Comb attachment|1
Figure C: adjust the cutting length with the slider accord-
ing to the desired hair length and read off the cutting
length using the marking on the side of the comb attach-
ment|1 (3, 4, 5, 6 mm). Now, shorten your beard step-by-
step.
• Use the beard trimmer attachment|13 without a comb at-
tachment|1, to cut the beard very short or to cut a mous-
tache and hairline.
• Using the switch for cutting length fine tuning|6 the cutting
length can be slightly varied with three levels (1: 0.8 mm /
2: 1.3 mm / 3: 1.8 mm).
• To trim your moustache, first comb it straight downwards.
Then use either the beard trimmer attachment|13 or the
precision trimmer attachment|4. Start at the centre above
the mouth and trim first one side, then the other.
GB 13