Thinning Hair; Cutting Hairlines And Beard - SilverCrest SHBS 500 B1 Mode D'emploi

__GRA93480_B2.book Seite 51 Montag, 9. September 2013 10:28 22
just the cutting length with the slider|10 and read off the cutting lengths on
the marking|8 on the side of the comb attachment|1.
• Start by cutting the hair in the neck or on the sides and cut towards the cen-
tre of the head. Then, cut the front section of the hair towards the centre of
the head.
• Hold the device in such a way that the comb attachment lies as flat as pos-
sible on the head. Move the device evenly through the hair.
• If possible, cut against direction of hair growth.
• In order to catch all the hair, move the device several times through each
section of the hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line for cutting lengths over 20 mm,
the device should be passed through the hair several times from different di-
rections.

6.3 Thinning hair

Use the thinning function to reduce the volume of the hair without changing its
length.
• Push the slider|3 to the left. The thinning function integrated into the shav-
ing head|9 is extended upwards.

6.4 Cutting hairlines and beard

WARNING! Risk of injury!
The points of the shaving head are sharp. Handle with care.
• Adjust the cutting length with the slider|10 according to the desired hair
length and read off the cutting length using the marking|8 on the side of
the comb attachment|1. Now, shorten your beard step-by-step.
• Use the device only with the shaving head|9 and without comb attach-
ment, to cut hair very short or to cut beard and hairline. In this way you
can cut hair lengths of 1-2 mm evenly.
GB 51