Operation; Changing The Attachments; Setting The Trim Length; Trimming Hair - SilverCrest HG03661 Instructions D'utilisation Et Consignes De Sécurité

Note: The blades can be oiled with or
without comb attachment
attachment .
12

Operation

Changing the attachments

Carefully place the desired comb attachment
onto the product as depicted in Fig. F. En-
11
sure that both recesses of the comb attachment
properly engage into the lateral detents at
11
both sides above the cutting unit
To remove the comb attachment
slide it forward and upwards using both
thumbs, as depicted in Fig. G.

Setting the trim length

To set different trim lengths, hold the upper part
of the product
2
the product into the desired position
5
(0.8–2.0 mm). The set trim length will be dis-
played on the length position indicator
which aligns with the dot-marking on the upper
part of the product

Trimming hair

Note: The hair being trimmed should be clean,
dry and untangled.
Carefully comb the hair using the supplied
comb to disentangle any potential knots.
17
Place the hairdressing cape
neck and nape to prevent bits of hair from
falling into the collar.
Begin by using the longer comb attachment
and trim the hair gradually to the desired length.
12 GB/IE/NI
and thinning
11
.
1
, press and
11
and twist the lower part of
4
.
2
around the
15
Note that the desired trim length can only be
achieved if the product is held perpendicularly
to the skin's surface.
Avoid making sudden movements when trim-
ming.
Switch the product on by pressing down the
travel lock
3a
switch to the „I" position. To maximize per-
3b
formance, slide the ON / OFF switch
„Turbo" position. The Turbo display
appear on the display if this is the case.
Always trim from the nape in the direction of
the top of the head, or from the forehead and
temples towards the centre of the head.
Guide the product slowly and steadily through
the hair. If possible, trim against the direction
of the hair's growth.
While doing so, hold the product in such a
way that the selected comb attachment
positioned as level as possible.
Move the product over the head several times
to collect all of the hair. To achieve a straight
line, move the product through the hair several
times from different directions.
Comb the hair repeatedly.
You can graduate the desired trim length of
the comb attachment
rotating the lower part of the product
cording to length position indicator
gradations differ by 0.3 mm.
Example:
Comb attachment 3.0 mm (trim length
3.8–5 mm):
Furthermost left
position (0.8 mm): short hair (3.8 mm)
Middle
position (1.4 mm): mid-length hair (4.4 mm)
Furthermost right
position (2.0 mm): long hair (5.0 mm)
11
and sliding the ON / OFF
8
more accurately by
11
4
to the
3b
will
is
11
ac-
5
. These