Selecting The Position - Tunze Multicontroller 7097 Mode D'emploi

Selecting the position

(1) The suitable wall has to be dry and protected against splashing water and humidity. By no means attach above
the aquarium!
(2) Observe the cable length of the units, control lamps should be visible; the foodtimer should be easily accessible!
(3) Place the cable connections in such a way that water cannot run down the cables and enter the Multicontroller.
Attachment of the Multicontroller 7097 with hook-and-loop
strips for smooth plastic surfaces
Adhere the strip on to the housing (4); for this purpose remove the protective foil and press on.
Prior to adhering the strip, please make sure that the surface is clean, free from grease and smooth. Subsequently,
remove the second protective foil and then position and adhere the Multicontroller at the requested position.
70 71