Quick CHC1103 Manuel D'installation page 36

SETTING THE CHAIN COUNTER
EN
DEVICE INFO
SW VERSION
S/N: XXXXX/YYZZ
SET DEFAULT
ARE YOU SURE?
YES NO
CHECK FLASH
CHECK FLASH
TRUE: XXXX
SUM: YYYY
CHECK EEPROM
CHECK EEPROM
TRUE: XXXX
SUM: YYYY
CAN MESSAGE
TX MSG: 000
RX MSG: 000
LAST ID: 000
CAN UPD: 000
CAN CONFIG
CAN PRIORITY
CAN BIT RATE
EXIT
CAN PRIORITY
SET VALUE:
MASTER SLAVE
CAN BIT RATE
SET VALUE:
62.5 KBPS
36
SETTINGS MENU - UTILITY - DEVICE INFO
This function allows viewing the version of the software installed on the device, as well as
serial number, week and year of production.
Where XXXXX is the serial number, YY is the week of production
and ZZ is the year the chain counter was produced.
SETTINGS MENU - UTILITY - SET DEFAULT
This function allows the user to enter the default values and RESTART the chain counter.
YES or NO can be entered.
SETTINGS MENU - UTILITY - CHECK FLASH (program memory)
This function shows the calculated FLASH memory checksum (SUM) and the one stored dur-
ing production (TRUE).
In order for the chain counter to operate properly the two values must match.
SETTINGS MENU - UTILITY - CONTROL EEPROM (data memory)
This function shows the calculated EEPROM memory checksum (SUM) and the one stored
(TRUE).
In order for the chain counter to operate properly the two values must match.
SETTINGS MENU - UTILITY - CAN MESSAGE
This function shows some information regarding CAN messages transmission state.
SETTINGS MENU - CAN CONFIGURATION
These options allow setting CAN priority and CAN bus interface speed.
SETTINGS MENU - CAN CONFIGURATION - CAN PRIORITY
This option allows the user to determine chain counter's priority in the CAN network
(see chapter MULTIPLE CHAIN COUNTERS).
MASTER and SLAVE can be entered (default: MASTER).
SETTINGS MENU - CAN CONFIGURATION - CAN BIT RATE
This option allows setting the communication speed of the CAN bus interface.
After setting, turn off and on again the instrument.
Selectable values: 62.5 - 125 - 250 Kbps (default: 62.5 Kbps)
CHC1103 IT EN FR - REV001A