Functions - Quick CHC1103 Manuel D'installation

SETTING THE CHAIN COUNTER
The chain counter has a several functions that can be personalized to satisfy user's requirements.
To go to the setting menu, press and hold key
As soon as the key is released a window similar to the one shown below is displayed:
p q
Use keys pand and
The data item that has been currently selected appears in reverse.
=
Use key (SELECT) to confirm the selected data item.
The following data items are provided on the settings menu, with the MASTER chain counter present on the network:
DATA ITEM
COUNTER RESET

FUNCTIONS

PERSONAL SET
LANGUAGE
CALIBRATION
AUTO CALIBRATE
UTILITY
CAN CONFIG
EXIT
THE STRUCTURE
OF THE MENUS:
CHC1103 IT EN FR - REV001A
=
SELECT) for more than 3 seconds.
(UP and DOWN) to select the data items within the menu.
SYNTHETIC DESCRIPTION
Reset the measure of chain lowered.
Automatic down and up alarm setting.
Chain counter personalization: contrast, back-lighting, light delay, key beep,
timed locking of the p and q (UP and DOWN) keys.
System date and time setting.
Chain counter calibration: setting of the measurement unit, development of the chain on the gypsy,
the number of magnets installed, and management of the windlass with free fall.
Automatic chain counter calibration.
Various chain counter controls.
MASTER/SLAVE selection in the case of multiple instruments and CAN bus speed setting.
Chain counter set-up menu exit.
COUNTER RESET
FUNCTIONS
PERSONAL SET
LANGUAGE
CALIBRATION
AUTO CALIBRATE
UTILITY
CAN CONFIG
EXIT
SETTING THE CHAIN COUNTER
UP ALARM
AUTO DOWN
CONTRAST
LIGHT
LIGHT DELAY
KEY BEEP
LOCKED KEYS
ENGLISH
ITALIANO
FRANCAIS
DEUTSCH
ESPANOL
SET MEASURE
GYPSY LAP
MAGNETS NUMBER
FREE FALL
SENSOR TEST
LCD TEST
DEVICE INFO
SET DEFAULT
CHECK FLASH
CHECK EEPROM
CAN MESSAGE
CAN PRIORITY
CAN BIT RATE
EN
SETTINGS
COUNTER RESET
FUNCTIONS
PERSONAL SET
LANGUAGE
CALIBRATION
31