Quick CHC1103 Manuel D'installation page 24

INSTALLATION
EN
INSTALLING THE SOCKET
The standard installation procedure is described below. Unfortunately we cannot describe a procedure applicable to all
types of windlasses. Adapt this procedure to satisfy your own individual requirements.
Find the spot most suitable for the socket based on the following criteria:
• The socket is to be installed in an area where it can be easily reached by the user.
• Select a clean, smooth, flat spot.
• A rear point that provides access to the socket's fixing surface must be present for installation and maintenance purposes.
• Leave enough space free behind the installation spot to conveniently run the socket's cable.
• The back of the socket must be protected against contact with water and moisture.
• Pay careful attention when drilling the panel or parts of the boat. This hole should not weaken or break/crack the boat's
structure.
The chain counter meets standard EMC (electromagnetic compatibility). In any case correct installation is fundamental in
order not to affect its performance or interfere with operation of instruments found near it.
For this reason the chain counter must be at least:
• 25 cm away from the compass.
• 50 cm away from any radio receivers.
• 1 m away from any radio transmitters (except for SSB).
• 2 m away from any radio transmitters SSB.
• 2 m away from the path of the radar beam.
After selecting the area where the instrument is to be installed, perform
the steps given below:
• Place the drilling template (pag. 61) on the surface where the socket will
be installed.
• Mark the center of each hole.
• Make the hole for the passage of the cable of the socket with a milling
cutter (25 mm / 1").
• Remove the template and any burrs present in the hole.
• Place the seal at the base of the socket.
• Run the cable through the hole made.
• Fix the socket tightening the 4 screws provided.
INSTALLING THE SUPPORT
The standard installation procedure is described below. Unfortunately we cannot describe a procedure applicable to all
the situations.
Adapt this procedure to satisfy your own individual requirements.
Find the spot most suitable for the support based on the following criteria:
• The support must be positioned so that it can easily be reached by the
operator.
• Choose a clean, smooth, flat location.
• Check that the back of the panel into which the screws of the support
will be tightened is free from passing cables, tubes, etc.
• Take particular attention when screwing into the panels or parts of the
boat. The screws must not weaken or cause the breakage of structure of
the boat.
• Place the support onto the chosen surface.
• Fix the support with the 2 screws provided.
24
CHC1103 IT EN FR - REV001A