Quick CHC1103 Manuel D'installation page 30

CHAIN COUNTER OPERATION
EN
TURNING THE TORCH ON AND OFF
Press and release button
in less than one second to shut off the torch.
When the instrument is turned on, the torch is always off, even if the instrument was shut off from the power supply with
the torch turned on.
MONITORING
The information given on the monitor line can be edited by pressing (the monitoring line will start to flash) and releasing
=
button (SELECT) within 1 to 3 seconds.
The following data can be displayed: chain speed, supply voltage and winch.
STOP
STOP
35.3
M
SPEED 0M/M
STOP
STOP
35.3
M
BATTERY
12.8V
STOP
STOP
WINCH
WINCH MODE
This mode must be used when carrying out winch operations with the windlass. In this configuration the mechanism that
moves the chain (gypsy) remains stationary while the drum can still turn.
To use the windlass for winch operations consult relative user manual.
ATTENTION: use this mode only if the windlass is configured for winch operations.
ATTENTION: in this mode the automatic down function is blocked, the up alarm function is deactivated and the
count is not updated.
Once activated the winch mode, the following window is displayed:
STOP
STOP
WINCH
ACTI V ATED
WINCH
30
=
(SELECT) in less than one second to turn on the torch. Press and release button
The precision of the chain speed reading is ±1% accurate.
The precision of the supply voltage reading is ± 1% accurate.
To select direction of drum rotation press the
down until the operation is complete, then release the button.
p q
While (UP) or (DOWN) button is pressed, the instrument will display a window like this:
If the instrument is turned off in winch mode, when turned on again it will display the speed
of chain movement.
p q
(UP) or (DOWN) button. Hold the button
CHC1103 IT EN FR - REV001A
=
(SELECT)