Quick CHC1103 Manuel D'installation page 34

SETTING THE CHAIN COUNTER
EN
CALIBRATION
SET MEASURE
GYPSY LAP
MAGNETS NUMBER
FREE FALL
EXIT
SET MEASURE
SET VALUE:
METERS FEET
SETTINGS MENU - CALIBRATION - GYPSY LAP
Use this option to set the measurement of the chain in one
gypsy lap. To obtain this value, remove the gypsy, wind the
chain around it and then measure its length.
Consult the User's manual of the windlass for more detailed
instructions on how to remove and re-install the gypsy.
F
It is extremely important that the value set for GYPSY LAP is precise as it affects the accuracy with which
the length of the lowered chain is measured
GYPSY LAP
SET VALUE:
10.0 CM
GYPSY LAP
SET VALUE:
10.0 INC
MAGNETS NUMBER
SET VALUE:
1
FREE FALL
SET VALUE:
0.5 S
ATTENTION: auto free fall management must be
activated exclusively with windlasses equipped with
auto free fall system. Refer to the instruction manual
relative to the windlass being used.
ATTENTION: If auto free fall management is activated,
the "no sensor" signal time will vary depending on the
value entered in the AUTO FREE FALL parameter and
the automatic descent function will be deactivated;
the latter will become active again once free fall
management is deactivated.
34
SETTINGS MENU - CALIBRATION
Use this option to calibrate the chain counter according to the windlass it is mounted on.
SETTINGS MENU - CALIBRATION - SET MEASURE
Use this option to select the unit of measurement relative to measurement of chain lowered.
Selectable options: METERS or FEET (default: METERS).
If the unit of measurement is set to METERS,
the settable values are from 0.1 to 999.9 cm (default: 10 cm).
If the unit of measurement is set to FEET,
the settable values are from 0.1 to 999.0 inc (default: 10 inc).
SETTINGS MENU - CALIBRATION - NUMBER OF MAGNETS
Use this option to set the number of magnets installed on the gypsy.
Selectable Values: 1 to 16 (default: 1).
SETTINGS MENU - CALIBRATION - AUTO FREE FALL
Through this management we set the time required by the windlass auto free fall system to
deactivate itself.
Select the available values: OFF, from 0.1s to 7s (default: OFF)
CADUTA LIBERA
SALITA
1.5
GYPSY LAP
M
0.1s - 7s
CHC1103 IT EN FR - REV001A
RISALITA