John Bean PEGASUS 200 Mode D'emploi page 84

Installation Instructions
IV. Testing procedures
Motor rotation check
This type of check must be made on machines at the
end of installation only.
• Press the turntable rotation control pedal: the wheel
must start and turn clockwise.
Should it rotate anticlockwise the machine must be
stopped and must not be used until it has been repaired
by an authorized technician.
ANY DAMAGE CAUSED BY NON APPLICATION OF
THE ABOVE INSTRUCTIONS SHALL NOT BE DEBITED
TO THE MANUFACTURER AND SHALL VOID THE
WARRANTY.
Pneumatic hose connection check
When first setting the machine into operation, check
hose connections and fittings for leakage.
v Instructing the operator
(Following applies only if a unit is installed by a service
Technician)
• Show the operator how to switch the unit on and off.
Operator's Manual Pegasus 200
84