John Bean PEGASUS 200 Mode D'emploi page 32

2
1
8
32
4
3
4.1-3
4.1-2
4.1-6
7
6
5
4.1-7
4.1-2
Layout
Tool holder arm
To prevent collisions with the wheel or the turntable,
the tool must be placed in the fully raised position,
unless already adjusted as so.
BRING THE TOOL INTO THE FULLY RAISED
POSITION TO PREVENT ANY COLLISION WITH THE
WHEEL OR THE TURNTABLE
Press all the way down with the LEFT foot, then release
the pedal (3, Fig.4.1-3); the tool holder arm rotates,
from the standby position, inwards.
Press and release again; the tool holder arm will rotate
outwards.
WARNING: THE OPERATIONS COULD BE
DANGEROUS. FOLLOW THE SAFETY INDICATIONS
SET OUT IN THE PLATES
Figure 4.1-2
WARNING: DANGER OF HANDS BEING CRUSHED
Figure 4.1-6
RANGER, MOVING PARTS
Bead breaker
To activate ascent/descent of the bead breaker arm
act on the manual control (5, Fig.4.1-7).
Control up; the bead breaker ascends.
Control down; the bead breaker descends.
Figure 4.1-2
WARNING: DANGER OF HANDS BEUING CRUSHED
The manual control (6, Fig.4.1-7) varies the working
angle of the disc; this makes penetration in the bead
seat easier.
Control down; the disc tilts.
Control up; the disc returns to its normal position.
To lock movement of the bead breaker horizontal slide,
act on the manual control (7, Fig.4.1-7).
Control right; the horizontal slide is free.
Control left; the horizontal slide stops.
The manual control (8, Fig.4.1-7) operates opening/
closing of the bead breaker arm, from the working
position to the standby position and vice versa.
Control up; the arm opens outwards.
Control down; the arm closes on the wheel.
Operator's Manual Pegasus 200