John Bean PEGASUS 200 Mode D'emploi page 64

1
1
3
R
G
T
64
2
4
3
6.0-3
2
6.0-4
F
S
6.0-5
Maintenance
carry out:
• Clean with a dry cloth
• Restore a thin film of protective oil
on the parts:
Figure 6.0-4
1) Wheel clamping hub nut
2) Vertical slide cylinder of tool
3) Pneumatic cylinder rods
Figure 6.0-5
• Check that the lubrication unit is working
properly.
One oil drop falling into the transparent cone G every 4-
5 complete strokes of the bead breaker indicates that
the correct amount of oil is being dispersed in the system.
If necessary,
• Adjust the unit using the screw 'R' to correct the
oil flow so it is as indicated above.
Every day,
carry out:
• Clean with a dry cloth
on the parts:
Figure 6.0-3
1) Plastic guards for wheel clamping tapers
2) Mount/demount tool plastic guards
3) Bead breaker disc
4) Plastic guards of Wheel turntable.
Operator's Manual Pegasus 200