John Bean PEGASUS 200 Mode D'emploi page 70

70
Trouble shooting
Turntable does not move up or down.
1. Extension position stop device jammed.
• Lubricate release device.
2. The protection hood under the turntable is broken
and dirt has got inside.
• Remove the hood from the base and clean the
grooved pin thoroughly.
• Call the authorized assistance service immediately
to have the hood replaced.
Machine damages alloy rims.
1. Plastic tool guard worn.
• Replace the plastic tool guard.
2. Tool is at wrong distance from rim.
• Call the authorized assistance service.
Irregular movement of swing arm.
Wheel lifter jammed.
1. Low air pressure.
• Check air line pressure.
2. Control cylinder defective.
• Call the authorized service center for assistance.
3. Control valve defective.
• Check oil level in the lubrication device and that latter
is working properly as described in the Maintenance
chapter.
• Call the authorized service center for assistance.
Operator's Manual Pegasus 200