John Bean PEGASUS 200 Mode D'emploi page 42

3
2
1
42
5
4
5.1.3-1
Operations
5.1.3 Locking
Figure 5.1.3-1
• Rotate the rim on the flange of the tyre lever, until
the drag device 1 is brought inside one of the
concentric holes of the rim.
• Place, on the Quick-Clamping Hub Nut with Pin
clamping device 2, the suitable taper and relative
plastic guard according to the diameter of the hole
and the type of rim in use.
• Insert the complete Quick-Clamping Hub Nut locking
tool in the centre of the rim.
• Raise the peg 3 at the head of the Pin and fully insert
the lock unit in the wheel holder seat.
• Release the central Peg 3 and make sure that the
locking spheres engage in the relative seats.
• Move the taper and the Quick-Clamping Hub Nut
closer to the wheel, freeing the ratchets 4 of the nut
itself.
• Tighten the nut all the way after opening the operating
handles 5.
The wheel is now locked in place and tire mount/
demount tasks can now be carried out.
Operator's Manual Pegasus 200