EUROM E-CONVECT METAL Mode D'emploi page 23

 Hang the frame over these screws and allow to drop into the grooves.
 Now mark the location of the two upper screws.
 Remove the frame, drill the upper holes and install plugs.
 Hang the frame again and screw both the upper and lower screws tightly to the
wall.
 Let the heater drop onto the hanging frame, with the fan openings in the base
falling over the hooks on the frame, so that the upper hooks on the hanging frame
sit in front of the recesses in the heater (diagram C).
 Now push the heater and the recesses over the upper hooks on the hanging
frame. The heater will be secured to the frame via the clamps on the upper hooks.
(diagram D). Check that the clamps have fallen properly inside the heater and are
securing it!
Take care! In order to ensure that the clamps are sufficiently secure, they face
slightly outwards and are made of slightly flexible metal. Be careful that the
hooks are not turned inwards, resulting in the clamps offering insufficient
securing force and the heater falling over!
Set-up and Operation
Comment: It is normal for the heater, when first used or after a long period of
inactivity, to give off an odour or a little smoke. This will cease after a short period.
Make sure the heater is turned off (On/Off switch to O). Now plug into an earthed,
correctly functioning 220-240V / 50Hz socket. Only connect the heater to an earthed
socket!
Turn the heater on by pushing the on/off switch to 'on' (I pushed in). A temperature
appears on the display. If this is higher or lower than the desired temperature, you
can press the + or – to set a higher or lower temperature. If the room temperature
falls under the desired temperature, the heater will switch on automatically (round
control light will come on) and then go off again once the desired temperature has
been reached.
To switch off, click the ON / OFF-switch to off. The heater switches off. Unplug.
Programmer
The heater is equipped with a programmer which can be used to set a functioning
schedule. Choose the method that best suits you:
 HO=home: Setting for 7 days per week.
 OF=office: Setting for five days per week; on Saturday and Sunday the heater
doesn't work.
 CA=cabin (guest room or similar): setting for a limited number of days (max. 40).
Choose the method that best suits you:
 The heater is switched off; plug in the socket.
 Press on the F button and keep this pressed. Now switch the heater on using the
On/Off switch (switch on I). The display will show: 22. After a few seconds, rE will
show on the display. You can now let go of the F button. After a few blinks, HO
(home) will appear on the display (blinking). By pressing on the
+ or – button, you can change this to OF (office) or CA (guest room). Confirm your
selection by pressing on the F button once again.
 A blinking '22' will now appear on the display. Now, you can set the standard
temperature by pressing the + (higher) or – (lower) button. For home use, set the
highest daily temperature; for office use, the lowest night temperature and for
23