EUROM E-CONVECT METAL Mode D'emploi page 22

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Do not use the heater before it has been installed in accordance with the
Choose a solid, flat and completely vertical wall made of non-flammable and non-
melting material on which to mount the heater (i.e. no wood, synthetic materials, etc!)

Decide where you want to mount the heater. Make sure that the heater has
sufficient space around it at all times and that no inflammable materials are
located nearby (see also safety instructions). Do not place the heater behind a
door! The heater's underside needs to be at least 5 cm above the floor, the sides
at least 20 cm from the side walls and the top at least 200 cm from the ceiling,
ceiling beams, etcetera.

Drill the lower two holes (diameter 8 mm, depth of 40 mm) according to diagram
A.
 Push plugs into the holes and screw in 2 screws until they protrude by 1 cm
(diagram B)
following instructions!
22