Triton TSPL 152 Mode D'emploi page 16

Troubleshooting
Problem
No function when ON/OFF Switch (6) is operated
Motor does not start
Poor surface finish after planing
Barrel not rotating
Vibration and abnormal noise
EN
16
350767/850827_Manual.indd 16
Possible cause
No power
Defective ON/OFF Switch
Carbon brushes worn
Chosen cutting depth too big
Blunt Blades (44)
Wood is damp
Broken Drive Belt (48)
STOP using tool immediately
Solution
Check power supply
Replace the ON/OFF Switch at an authorised Triton service
centre
Brushes need replacing
Reduce cutting depth and work in several passes instead
Turn or replace Blades (see 'Changing blades')
Switch 'OFF' immediately. Evaluate and correct positioning
of Blades (see 'Blade replacement')
See 'Replacing the Drive Belt' and replace Belt
Re-check all user accessible parts are secure and correctly
fitted
Contact an authorised Triton service centre
13/02/2020 10:09