Lighting The Main Burner And Regulating The Temperature; Turning Out The Oven; Maintenance - OFFCAR Stile 80FCG10LL Notice D'installation Et D'emploi

7.2.2 Lighting the main burner and regulating the temperature

With the pilot flame lit, turn the knob of the thermostat "M" left and select the
required cooking temperature. The knob of the thermostat is numbered from
1 to 8:
- n. 1 = 100°; n. 2 = 135°; n. 3 = 170°; n. 4 = 200°;
- n. 5 = 235°; n. 6 = 270°; n. 7 = 300°; n. 8 = 340°
Regulating the thermostat entails automatic lighting and turning out of the
main burner (on-off regulation, there is not minimum). If the thermostat knob
is turned right as far as the stop, the main burner goes out and only the pilot
flame remains lit.

7.2.3 Turning out the oven

In order to turn out the pilot flame and also prevent lighting of the main burner, press the off button "O" down. The safety
device installed prevents relighting of the appliance for a few seconds.
We recommend signing a maintenance contract at last once a year.
Clean the cooking plate after use with an emery cloth. After cleaning a thin layer of cooking oil has to be applied to the
plate surface in order to preserve it better.
Every evening, at the end of work, the appliance must be cleaned thoroughly. Daily cleaning of the appliance guarantees
perfect working and longer life of the appliance itself.
Before starting cleaning disconnect the appliance from the mains; remove all the removable parts of the oven and wash
them separately.
During cleaning do not wash the appliance with direct or pressurised jets of water!
The parts in stainless steel have to be cleaned gently, using warm water. If you use soap or detergent, make sure that
they do not contain abrasive products and that they are recommended for cleaning stainless steel.
If the appliance is not used for a certain period of time, close the gas supply cock. In the case of a fault in the appliance or
malfunctioning close the main gas inlet cock and call the technical service centre.
All repairs and fault remedying must be carried out by a skilled installer.

8. MAINTENANCE

- 19 -
Fig. 9