Publicité
Installation
During operation, the following environmental conditions must be
respected:
To connect the controller to the pump use the specific cables
supplied. See the appendix "Technical Information" for detailed
information about the above mentioned and the other connections.
HV On/Off by front panel:
Move the switch on Front Panel
Tab. 1
Input Voltage
24 Vdc ± 10 %
< 19 Vdc for more of
1 minute
< 15 Vdc for more of
2 minutes
Ion Pumps Controller 24 V User Manual / 87-900-127-01 (C)
temperature: from 0 °C to +45 °C
relative humidity: 0 – 95 % (non-condensing)
OK
HV On and battery Warning with both LED Blink
simultaneously 1 blink every 2 sec
HV OFF and no blink of LED
Installation Procedure
Installation
4
27/42
Publicité
Chapitres
