IKA Roller 6 basic Mode D'emploi page 14

Operating modes A and B
Operating mode A
The device does not restart automatically when power is restored after a power outage.
Operating mode B
The device restarts automatically when power is restored after a power outage, using the set values, and displays the (Pr) symbol to
indicate that there has been a power outage within a certain period of time.
Switching between operating modes
To switch between operating modes, switch the device off, then keep the "Start/Stop" button (F) depressed and press the "Power"
button (L).
Caution! Do not change the tube fences or rollers whilst the device is in operation!
Stop the device by pressing the "Start/Stop" button (F). Do not use your hand to stop the device.
Press the "Power" button (L) to switch the device off.
Removal / fi tting tube fences
The front and back tube fences must be in position when the device is in operation.
The side tube fences are optional; for certain sizes of tubes the side tube fences offer
additional safety.
Fitting
- Plug in the tube fences (1).
Removal
- Take the tube fences off (1).
Fitting / removing the rollers
Removal
- Take the tube fences off (1).
- Release the roller and pull it out (2).
- Remove the roller completely (3).
Fitting
- Fitting is the reverse of removal.
A "click" confi rms achievement of the correct position.
1
1
2
3
14