Lcd Screen - Sony Handycam HDR-CX190 Mode D'emploi

If moisture condensation has occurred

Leave your camcorder for about 1 hour without
turning it on.
Note on moisture condensation

Moisture may condense when you bring your
camcorder from a cold place into a warm place
(or vice versa) or when you use your camcorder
in a humid place as follows:
You bring your camcorder from a ski slope

into a place warmed up by a heating device.
You bring your camcorder from an air

conditioned car or room into a hot place
outside.
You use your camcorder after a squall or a

rain.
You use your camcorder in a hot and humid

place.
How to prevent moisture condensation

When you bring your camcorder from a cold
place into a warm place, put your camcorder in
a plastic bag and seal it tightly. Remove the bag
when the air temperature inside the plastic bag
has reached the surrounding temperature (after
about 1 hour).
When the camcorder is connected to
a computer or accessories
Do not try to format the recording media of the

camcorder using a computer. If you do so, your
camcorder may not operate correctly.
When connecting the camcorder to another

device with communication cables, be sure to
insert the connector plug in the correct way.
Pushing the plug forcibly into the terminal
will damage the terminal and may result in a
malfunction of the camcorder
When the camcorder is connected to other

devices through a USB connection and the
power of the camcorder is turned on, do not
close the LCD panel. The image data that has
been recorded may be lost.
Notes on optional accessories
We recommend using genuine Sony accessories.

Genuine Sony accessories may not be available

in some countries/regions.

LCD screen

Do not apply excessive pressure on the LCD

screen, as it may cause uneven color and other
damage.
If your camcorder is used in a cold place, a

residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of

the LCD screen may heat up. This is not a
malfunction.
To clean the LCD screen
If fingerprints or dust make the LCD screen

dirty, it is recommended that you use a soft
cloth to clean it.
To clean the projector lens (HDR-
PJ200/PJ210)
Wipe the lens gently with a soft cloth such as a

cleaning cloth or glass cleaning cloth.
Stubborn stains may be removed with a soft

cloth such as a cleaning cloth or glass cleaning
cloth lightly dampened with water.
Never use a solvent such as alcohol, benzene or

thinner; acid, alkaline or abrasive detergent; or
a chemical cleaning cloth, as they will damage
the lens surface.
US
1