Sony Handycam HDR-CX190 Mode D'emploi page 72

On adjustment of the touch panel
([Calibration]) (HDR-CX200/CX210/
PJ200/PJ210)
The buttons on the touch panel may not
work correctly. If this happens, follow the
procedure below. It is recommended that
you connect your camcorder to the wall
outlet (wall socket) using the supplied AC
Adaptor during the operation.
  [Setup]  [
[Calibration].

Touch "" displayed on the screen with the
corner of memory card or the like 3 times.
Touch [Cancel] to cancel calibration.
Notes
If you did not press the right spot, try the

calibration again.
Do not use a sharp-pointed object for

calibration. Doing so may damage the LCD
screen.
You cannot calibrate the LCD screen if it is

rotated, or closed with the screen facing out.
On handling the casing
If the casing is soiled, clean the camcorder body

with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
Avoid the following to avoid damage to the

finish:
Using chemicals such as thinner, benzine,

alcohol, chemical cloths, repellent, insecticide
and sunscreen
Handling the camcorder with above

substances on your hands
US

General Settings] 
Leaving the casing in contact with rubber or

vinyl objects for a long period of time
About care and storage of the lens
Wipe the surface of the lens clean with a soft

cloth in the following instances:
When there are fingerprints on the lens

surface
In hot or humid locations

When the lens is exposed to salty air such as

at the seaside
Store in a well-ventilated location subject to

little dirt or dust.
To prevent mold, periodically clean the lens as

described above.
On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date,
time, and other settings even when the
LCD screen is closed. The pre-installed
rechargeable battery is always charged
while your camcorder is connected to the
wall outlet (wall socket) via the AC Adaptor
or while the battery pack is attached. The
rechargeable battery will be fully discharged
in about 3 months if you do not use your
camcorder at all. Use your camcorder after
charging the pre-installed rechargeable
battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.