MZ electronic EV-030 Instructions D'utilisation page 25

BARBOTIN circumference setting (in cm or inches) on sensor menu: the value to be entered is the
circumference on chain winding point. If this value is not available in windlass technical records, it is
necessary to measure chain length which the gypsy can house on its circumference. This measure
expressed in centimeters (or inches according to the measure set) is the value which has to be entered in
the Barbotin parameters
Setting the DIVIDER in the Sensor menu: if a standard sensor is used, this value must be set to
1 while if an electronic sensor is used it must be equal to the number of sensor pulses for each turn of
the barbotin:
Check menu
Use the (DOWN) or
Sensor Checks
The purpose of this function is to check the
state of the sensor:
EV-030
CIRCUMFERENCE OF THE BARBOTIN
Tests
S e n s . C h e c k s
LCD Test
S w . V e r s i o n
W o r k H o u r s
E x i t
(UP) key to move around the parameters.
Select with
1 . 0 1
0
25
English
Rev. 15 – 2022