MZ electronic EV-030 Instructions D'utilisation page 20

Starting up
The chain counter features a graphic display and three keys:
also a buzzer that indicates the pressing of the keys or attracts the user's attention in particular conditions
(alarm triggering).
The ON key switches on the display and enables the other two keys. It must be used to access the
parameter setting menus. For selecting the parameters to be modified and to confirm the values set. The
display backlight will switch off 30 seconds after the last command given (adjustable default time – see
"BkLight Time").
The UP key commands the hoisting of the anchor and the
DOWN key casts it. When the key is released, the action is
stopped. During parameter setting, the two keys allow the User
to move around the menu and vary parameter values.
When switched on, the instrument will make a beep and the following page will appear for a few seconds:
Once the initialisation procedure is complete, the main page will appear.
Where:
STATUS: indicates the status of the instrument and any failure.
SPEED': indicates the chain speed during hoisting or lowering in meters per minute or feet per minute.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
MONITORING: indicates the power supply voltage.
ICONS: this is the part of the display bearing the icons that indicate the hoisting or casting of the anchor
and any failure.
When the instrument is turned on for the first time, it will set up as programmed in the factory (see table).
SSS ENABLE: this is the abilitation of the "Secure Sail System".
counter with the appropriate power unit
EV-030
Stop
STATUS
0.0
SPEED'
COUNT
MONITORING
V=11.6
(ON),
metres / minute
feet / minute
0.0
f
metres / feet
SSS=OFF
SSS Enable
This feature is available by combining the
20
English
(UP) and (DOWN). There is
ICONS
Rev. 15 – 2022