Publicité
Les langues disponibles
Les langues disponibles
Connect the machine with the black fog conducting hose it is a three-meter pipe. The
length of the pipe can be adjusted to fit the actual need. (refer to figure 4)
Fill Antari FLC super fast dissipating liquid or FLR light fog liquid to the tank, tighten the
tank cap. (refer to figure 5)
-Operation
Connect the power cord to a grounded outlet, press down two sets of power switches
located at the back side of the machine. Please press the power switch of the
compressor below first and then the power switch of the fog machine. The warm up
process is started. The
While the unit is warming up, fog output will not be possible yet. Please wait till the LCD
screen shows "Ready To Fog".
Program the necessary menu settings with the control panel of the D-20 controller.
(refer to chapter D-20 controller).
The
DNG
-200 is equipped with a
each are located at the back panel of the machine for optional use. (refer to chapter
DMX512 settings)
When operating the machine for the first time, wait until the controller's
shows "Ready To Fog". Actuate the button
output from the machine. Thus the air in the liquid pipe is drained out. Once the fog
comes out smoothly, the D-20 controller can be set. If the machine is used infrequently,
please follow this procedure every time it is used to drain out the air.
The heater average temperature of the
-D-20
LCD
Screen Controller
The D-20 controller is equipped with a 2-meter line, a 5-pin
screen displaying all operation statuses of the fog machine. The interface allows the
operator to customize fog machine functions by adjusting the fogging duration, interval,
and
volume
as well as the
current operating parameters are automatically stored in non-volatile memory, allowing
the machine to be powered down without losing function settings.
-Configuration of the buttons
FUNCTION
VOLUME
MANUAL
TIMER
Figure 4
LCD
screen on the D-20 controller will show "Warming up".
DMX
512 system. 3-pin and 5-pin
Manual
DNG
-200 is 220°C.
DMX
address
. There are six buttons on the control board. All
1.
Interval Set
Duration Set
Volume Out
Nonstop Burst
High Volume
Medium Volume
Low Volume
DMX
512 Add
;
DMX
LCD
for a few seconds to initiate fog
XLR
connector, and an
2.
UP
and
DOWN
3.
TIMER
TIMER
4.
VOLUME
VOLUME
5.
MANUAL
MANUAL
Figure 5
-
connectors
screen
LCD
Publicité
