Saf-Fro DIGISTEP 255C Manuel D'utilisation page 19

Transport & Lifting
Falling equipment can cause injury and
damage to unit.
To safety transport and lift DIGISTEP 255C & 305C (see
the Figure 18):

Use equipment of adequate capacity to lift and support
unit.

Always lift and support unit using both eye bolts.

Do not use one eye bolt to lift or support unit.

Lift only power source without gas cylinder , cooler
and wire feeder, or any other accessories.

Screw down an eye bolt and apply load axially in 45
degree angle in accordance to the Figure 16.

Ensure equal length of lifting lines.

Do not use handle to lift or support unit.
255C & 305C
DIGISTEP
max 45°
Figure 18.
English
WARNING
Customer Assistance Policy
The business of The Lincoln Electric Company is
manufacturing and selling high quality welding equipment,
consumables, and cutting equipment. Our challenge is to
meet the needs of our customers and to exceed their
expectations. On occasion, purchasers may ask Lincoln
Electric for advice or information about their use of our
products. We respond to our customers based on the best
information in our possession at that time. Lincoln Electric
is not in a position to warrant or guarantee such advice,
and assumes no liability, with respect to such information
or advice. We expressly disclaim any warranty of any
kind, including any warranty of fitness for any customer's
particular purpose, with respect to such information or
advice. As a matter of practical consideration, we also
cannot assume any responsibility for updating or
correcting any such information or advice once it has
been given, nor does the provision of information or
advice create, expand or alter any warranty with respect
to the sale of our products.
Lincoln Electric is a responsive manufacturer, but the
selection and use of specific products sold by Lincoln
Electric is solely within the control of, and remains the sole
responsibility of the customer. Many variables beyond the
control of Lincoln Electric affect the results obtained in
applying these types of fabrication methods and service
requirements.
Subject to Change – This information is accurate to the
best of our knowledge at the time of printing. Please refer
to www.saf-fro.com for any updated information.
15 English