Saf-Fro DIGISTEP 255C Manuel D'utilisation page 15


Place the adapter of spool type S200 [29] on the
spindle [27] making certain the spindle brake pin [28]
is put in the hole in back side of the adapter [29]. The
adapter of spool type S200 can be purchased
separately (see "Accessories" chapter).

Place the spool type S200 [31] on the spindle [27]
making certain that the adapter brake pin [30] is put in
the hole in the back side of the spool.
WARNING
Position the spool type S200 so that it will rotate in a
direction when feeding so as to be de-reeled from bottom
of the spool.

Re-install the locking nut [25]. Make sure that the
locking nut is tightened.
Wire Spool Type B300 Loading
WARNING
Turn off the power source while mounting electrode wire.
28
Figure 10.

Turn the machine off.

Open the right side panel.

Unscrew the Locking Nut [25] and remove it from the
spindle [27].

Place the adapter of spool type B300 [32] on the
spindle [27].Make certain that the spindle brake pin
[28] is put in the hole in the back side of the adapter.
The adapter of spool type B300 can be purchased
separately (see "Accessories" chapter).

Re-install the locking nut [25]. Make sure that the
locking nut is tightened.
34
32
Figure 11.

Rotate the spindle and adapter so the retaining spring
[33] is at the 12 o'clock position.
English
27
32
25
33
33
35
36

Place the spool type B300 [35] on the adapter [32].
Set one of the B300 inside cage wires [36] on the slot
[34] in the retaining spring tab [33] and slide the spool
onto the adapter.
Position the spool type B300 so that it will rotate in a
direction when feeding so as to be de-reeled from bottom
of the spool.
Wire Spool Type Readi-Reel
Turn off the power source while mounting electrode wire.
27
28 37

Turn the machine off.

Open the right side panel.

Unscrew the locking nut [25] and remove it from the
spindle [27].

Place the adapter of spool type Readi-Reel
the spindle [27].Make certain that the spindle brake pin
[28] is put in the hole in the back side of the adapter.
The adapter of spool type Readi-Reel
purchased separately (see "Accessories" chapter).

Re-install the locking nut [25]. Make sure that the
locking nut is tightened.

Rotate the spindle and adapter so the retaining spring
[38] is at the 12 o'clock position.

Place the spool type Readi-Reel
[37]. Set one of the Readi-Reel
on the slot [39] in the retaining spring tab [38].
11
WARNING
33
35
Figure 12.
®
Loading
WARNING
38 40
39
36
Figure 13.
®
®
® [40] on the adapter
® inside cage wires [36]
25
[37] on
can be
English