HQ Power VDPDMXC173 Mode D'emploi page 4

b. Rear Panel
1. POWER switch: to switch the device on/off.
2. DC INPUT: 12V-20Vdc/250mA min, connect to AC outlet through an AC/DC adaptor.
3. DMX polarity selector: to select the polarity for DMX output.
4. DMX output
5. MIDI THRU: to transmit MIDI data received on MIDI IN.
6. MIDI IN: to receive MIDI data.
7. AUDIO line input: range 100mV~1Vpp. If it's connected, the built-in microphone is disabled and vice versa.
8. FOOT CONTROL: a foot controller can be connected for remote control
1 STEP+
2 PATTERN+
3 STAND BY
4 FULL ON
5 Common
Foot controller commands:
1. STAND BY button: press to change the STAND BY status.
2. FULL ON button: press this button to put channel 1-8 full on, overriding stand by.
3. STEP+ button: in chase mode, press to execute the pattern by one step. Pressing for more than one second would
increase the pattern by 10 steps/second.
4. PATTERN+ button: in chase mode, press to select pattern by plus one, press for more than one second would
increase the pattern quickly till the maximum and then increase from 01.
5. CONTROL outputs: same as the control inputs.
c. MIDI setting
1. Note data
Note number
22-81
82-97
99
101
102
2. If midi signal disappears, 10 min. later the matching indicator is off and the midi setting are dumped.
3. The patterns generated by midi are not controlled by the LEVEL knob and are not shown on the LCD. All turned on
patterns are executed synchronously and the terminal level is synthesized by the levels of the turned on patterns.
d. Operation
• RUN PATTERN:
1. Press appropriate function button(s) to select desired chasing mode from AUTO, MANUAL, AUDIO and TAP
SYNC, the LCD shows the pattern and the step.
2. Press PATTERN+ or PATTERN- to select desired pattern from 30 built-in patterns (31-60) and 30 variable
patterns(1-30). If the right two digits show 00, the pattern is blank or has been deleted.
VDPDMXC173
Velocity
master level for pattern
channel dimmer
Function
turn on/off 1-60 patterns
identical to that set by flash 1-16
FULL ON
execute the pattern by one step
change the STAND BY status
- 4 -
Fig.2
VELLEMAN