Technical Specifications - HQ Power SMOOTH SKY LASER Notice D'emploi

5. Overview
Refer to the illustration on page 2 of this manual.
1 lasers clockwise/anti-clockwise rotation
2 lasers rotation speed adjustment
3 red laser strobe speed adjustment
4 green laser strobe speed adjustment
5 red and green lasers on/off switch
6 on/off switch
7 DC power input
6. Use
• Make sure the device is switched off by flicking the on/off switch to O [6].
• Insert the power plug of the included PSU into the power input [7].
• Connect the PSU to the mains.
• Switch on the device.
• Adjust the laser and LED outputs using the adjustment knobs [1~5, 8~13].
• Switch off the device after use.

7. Technical Specifications

power supply
power consumption
laser output
red
green
LED
cooling
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.hqpower.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv.
All worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced
to any electronic medium or otherwise without the prior written consent of the copyright holder.
21.04.2010
All manuals and user guides at all-guides.com
230 VAC~50 Hz through 5 VDC PSU (incl.)
15 W
120 mW @ 650 nm
40 mW @ 532 nm
blue @ 470 nm
air-cooled
260 x 200 x 240 mm
3 kg
VDL160LL
8 left LED clockwise/anti-clockwise rotation
9 left LED rotation speed adjustment
10 left LED brightness adjustment
11 right LED clockwise/anti-clockwise rotation
12 right LED rotation speed adjustment
13 right LED brightness adjustment
4
©Velleman nv