JUKI CP-180 Manuel D'utilisation page 34

(4) Rectangular stitching pattern
1
Sewing pattern
C
1
1) Press rectangular stitching pattern switch 1 on the control panel to select the rectangular stitching pattern.
2) The rectangular stitching pattern is selected. Now, the predetermined number of stitches and other sewing
data are shown on the control panel.
3) To change the number of stitches of the processes in the rectangular stitching pattern, operate switches 5
(for processes C and D) to change the number of stitches for processes C and D.
Select the reverse feed stitching accordingly. To change the number of reverse-feed stitches, operate
switches 4 for setting the number of stitches for processes A and B.
(Adjustable range : A, B = 0 to 19 stitches, C, D = 0 to 99 stitches)
4) Four different kinds of stitching patterns can be performed according to the combination of ON/OFF set-
tings of automatic reverse stitching (for start) switch 2 and automatic reverse stitching (for end) switch 3 .
5) Furthermore, the double reverse stitching mode can be specifi ed by operating double reverse stitching (for
start) switch 6 and double reverse stitching (for end) switch 7 .
At each step the sewing machine automatically stops after sewing the predetermined number of stitches.
At this time, if the touch-back switch is operated, the sewing machine runs at a low speed (stitch compen-
sation operation). Also, at the last process, if the pedal is returned to its neutral position and depressed its
front part again, the sewing can be continued regardless of the setting of number of stitches.
6) If automatic thread trimming switch 8 is turned ON, the sewing machine will automatically perform thread
trimming after the completion of the last process. (If the automatic reverse stitching (for end) is selected,
the sewing machine will automatically perform thread trimming after it fi nishes the automatic reverse stitch-
ing (for end).)
7) If thread trimming prohibiting function 9 is chosen, the machine will stop with the needle up without per-
forming thread trimming.
8) If one-shot automatic stitching function !0 is chosen, the machine will automatically perform sewing at a
stretch until the number of stitches specifi ed is reached, at the predetermined sewing speed by depressing
the pedal while the sewing machine is engaged in the sewing of process C or D. The machine performs
thread trimming in the last process of one-shot automatic stitching pattern.
9) For the sewing machine equipped with an auto-lifter, the presser foot will automatically go up after the com-
pletion of each sewing process.
6 2
7 3
OFF
A
B
A
D
B
C C
D
OFF
1 4 5
ON
A
A A
B B
D
C C
D
OFF
- 8 -
!0
8 9
OFF
B
A
D
B
C C
D
ON
ON
A
B
D
C
D
ON