Lutron GRAFIK Eye. NTGRX-4S Instructions D'installation page 7

Wallbox Mounting
Frame
EGRX-4S/4S-IR Mounting Diagram
System Communications
In order for Wallstations to communicate with a Control Unit, each Wallstation must be individually configured to "talk" by putting the Wallstation
in setup mode.
1. Put the Wallstation in setup mode (only one Wallstation can be in setup mode at a time).
NTGRX-4S/4S-IR/4B, EGRX Controls, GRX-4S-DW, NTGRX-2B-SL: Press and hold the buttons indicated for about 3 seconds, until the
LED(s) start cycling.
NTGRX-4S/4S-IR
Press here for
"talk"
LUTRON
LEDs cycle
NTGRX-4M/NTGRX-4PS: Press and hold the buttons indicated for about 3 seconds, until the first LED flashes.
Occupant Copy
Thread all four screws before tightening.
Carrier Faceplate
NTGRX-4B
LUTRON
NTGRX-4M
LUTRON
Wall
Mounting
Frame
Wallbox
EGRX-4S/4S-IR Mounting Frame Orientation
EGRX-4S/4S-IR/-8S/-8S-IR GRX-4S-DW
EGRX-2B-SL
LUTRON
NTGRX-4PS
1
2
3
4
PARTITION STATUS
OPEN
7
NTGRX-2B-SL
Installation Instructions