Troubleshooting - Scheppach HS111 Traduction Des Instructions D'origine

18. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Problem
Saw blade gets loose after
turning off the motor
Motor does not start
Motor not supplying power,
fuse tripping
Burn areas at the cutting
surface
Motor turning sense incor-
rect
Possible cause
Fixing nut not tight enough
Mains fuse blown
Extension cable defect
Connections to the motor or switch
not OK
Motor or switch defective
Cross section of the extension cable
insufficient
Overload due to blunt saw blade
Blunt saw blade
Wrong saw blade
Capacitor defective
Incorrect connection
www.scheppach.com
Help
Tighten fixing nut with right-hand thread
Check the mains fuse
Replace the extension cable
Have it checked by an electrician
Have it checked by an electrician
See "Electrical Connection" in the operating
manual
Replace saw blade
Sharpen saw blade, replace
Replace saw blade
Commission check by an electrician
Have an electrician transpose the wall plug
poles
GB | 45