Mounting The Camera Using The Velcro Strap - Minox ACX 100 Mode D'emploi

adapter will be mounted. Attach the adhesive side of
the other Velcro half to the adapter and then press
the adapter firmly onto the helmet, bringing the two
Velcro halves together. Slide the mounting bracket
(6) on the bottom of the action cam onto the adapter
until you hear an audible click (see Fig. 7). Carefully
move the camera and helmet from side to side to en-
sure that the camera is firmly in place.

Mounting the camera using the Velcro strap*

Insert the strap into one of the openings of the adapt-
er with the Velcro side up, ensuring that the strap runs
underneath the mounting adapter. Pull the strap up
and through the other side of the adapter. Pull the
strap through the openings until the buckle is posi-
tioned snugly against the adapter.
Position the adapter over the centre of the helmet and
insert the strap through one of the ventilation open-
ings. Pull the strap up and through a parallel ventila-
tion opening and then through the buckle near the
mounting bracket – be sure that the camera is aligned
vertically and as central as possible on the helmet.
Tightly fasten the Velcro sides of the strap together
to avoid any unnecessary movement of the camera.
24
Fig. 8
Fig. 10
Fig. 12
Fig. 9
Fig. 11
Fig. 13