Mounting The Camera; Setup And Operating Mode; Setup Mode; Operating Mode - Minox DTC 450 SLIM Mode D'emploi

5. Press the OK button (11).
6. Using the down arrow key (11), choose the language
you would like to use (highlighted in black).
7. Press the OK button (11).
8. The camera returns to the "Main menu". The l
anguage is now set to the one you have selected.

Mounting the camera

On the outer casing of the camera there are two strap
mounts (17) attached to each side which can be used to
mount the camera. The mounting straps included in the
delivery are fed through the strap mounts (17). The cam-
era is fastened with the latches on the mounting straps.
Additionally, the camera can be secured using standard
cables by feeding them through the eyelets provided (18).

Setup and operating mode

Your camera has two mode settings:

1. Setup mode

Switch your DTC 450 camera to the "Setup mode" (SETUP
= setup mode, main switch (12) in top position). In this set-
ting you can adjust the programming of the camera as well
as all display settings such as date, time, temperature etc.
that are to be later displayed on the photos or video clips.
2. Operation mode
Switch your DTC 450 camera to "operating mode" (ON =
operation mode, main switch (12) in bottom position). In
40
this mode, your DTC 450 camera automatically accepts
the new settings which you previously programmed in
the "Setup mode".
Note: The red activating LED (5) will blink for a few
seconds before the camera is ready for use and you
will see the actual shooting area on the display screen.

Menu functions and settings

Preview

In the main menu, go to the menu option "Live Preview"
and press the OK button (11). This option allows you to
display a current image on the LCD display (6) of your
DTC 450 camera (3). The function is useful for alignment
of the DTC 450, since you can identify the shooting area
when you are not directly in front of the lens (3). In the
LCD display (6), the following is displayed: The battery
status symbol and the symbol for the inserted SD card
are indicated on the top right area. If the SD card is not
inserted, your DTC 450 reports the "No SD card" message
when you switch to setup or operating mode. Press the
menu button (13) to access the main menu again.

Playback photo/video

In the main menu, go to the menu option "Playback
photo/video" and press the OK button (11). The number
of photos or video recordings is displayed in the LCD
screen (6). If the shot is a video, the play symbol, cam-
era symbol and stop symbol will be displayed in the top
41