My First Video; Begin Recording; Stop Recording; Playback - Minox ACX 100 Mode D'emploi

My first video

Begin recording

To begin recording, push
the main switch (4) to-
wards the module tube.
A red marking will
now appear below the
switch. The red LED
(5) will first blink four
times. The recording will
begin as soon as the LED
lights up permanently.

Stop recording

Push the main switch
back until the red mark-
ing is no longer visible.
The red LED (5) will blink
several times while the
camera saves the record-
ing to the SD card. The
storage process is fin-
ished when the LED stops
blinking – the camera will
then turn itself off.
22
Fig. 3
Red Marking:
Main switch in the
ON position
Fig. 4
Main switch in the
OFF position

Playback

Your videos can be viewed on a PC, laptop or similar
device. Turn your MINOX ACX 100 off and connect it
to your device using the USB cable. Turn your cam-
era on by pushing the main switch (4) forward. Your
MINOX ACX 100 will now be recognised as a mass-
storage device. As no software is required, you can
view your videos on practically any PC or laptop.
Note: Please pay attention to the recommended
system requirements.

The LED indicators

Warning when the memory card is almost full

If the SD memory card is almost full, the middle LED
(14) will begin to blink red. If the card is full, the MI-
NOX ACX 100 will automatically stop recording and
the middle LED will light up red for 30 seconds. After
a further 30 seconds, the camera will turn itself off.

Warning when the battery charge is low

If the battery is getting low on power, the right LED
(15) will begin to blink green. If the battery is too