Simco-Ion ThunderION IQ 2.0 Notice D'utilisation page 69

Fit the anti-static bar:
 Directly in front of the place where static electricity causes problems.
 With the emitters facing in the direction of the material to be neutralised.
 In places where the material is neutralized, it must have a layer of air under it.
 The correct distance from the anti-static bar to the material should be established by
experiment (for operating distance see technical specifications).
Normally the effectiveness of the bar increases with decreasing the distance to the web
(not below minimum distance! ).
 The emitters of the anti-static bar must not be covered.
ThunderION2ThunderIONIQ2_UM_9752160050_NL_D_GB_F_V2_3
Figure 5
Figure 6
68