Antari S-100X Mode D'emploi page 6

2. Turn on the machine by pressing the red power switch on the rear of the unit and make
sure the red indicator that is located above the Power switch is lit.
The units can be controlled by either DMX or the SC-2 volume remote control. See the
respective topics below:
3. Connect the remote control's male 4-pin plug to the machines' INPUT socket and make
sure the red "POWER" indicator is lit.
4. Press ON/OFF button, the IN USE indicator lights up green and the machine is ready to
operate (during this procedure, the machine's fan and motors are operating).
5. Use the adjustable knob "OUTPUT VOLUME" on the SC-2 Volume Remote controller to
set an output value between 10% and 100%.
DMX Connector Pin Assignment
The machine provides a 3-pin XLR connector for DMX connection. The diagram below
indicates pin assignment information.
Pin
1
2
3
DMX Control
a) Connect the DMX cord to the DMX IN socket on the rear of the machine.
b) Test the system by activating the snow system's selected DMX channel. When the
channel value is increased the snow machine should produce snow at a steadily
increasing rate. The unit is OFF when a value between 0-5 is selected. It will reach 100%
output once the channel is set to 255.
Function
Ground
Data-
Data+
6