Antari S-100X Mode D'emploi page 4

S-100X & S-200X Snow Machine.
Use only the high-quality snow liquid that your dealer recommends.

Always make sure there is sufficient liquid in the machine's liquid tank.

If your ANTARI machine fails to work properly, discontinue use immediately. Drain all liquid

from the tank, pack the unit securely (preferably in the original packing material), and
return it to your ANTARI dealer for service.
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has
arrived intact.
If any equipment is missing contact your ANTARI dealer immediately.
The shipping carton should contain the following Items:
1. Snow machine with power cable
2. SC-2 volume remote controller
3. Fluid tank
4. Hanging bracket
5. Screw set and user manual
Before beginning your initial setup of the ANTARI S-100X & S-200X Snow Machine, make
sure that there is no evident damage caused by transportation. In the event that the unit's
housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting
your ANTARI dealer for assistance.
Setup
1. Remove all packing materials from shipping box. Check that all foam and plastic padding
is removed.
2. Place the machine on a flat surface and follow the steps below.
3. Assemble the hanging bracket on the machine, use the M8 screws to position the hanging
4