Optional Extras - BFT DEIMOS ULTRA BT A 400 Instructions D'utilisation Et D'installation

Logic Definition
Configuration
of safety input
SAFE 1
SAFE 1.
72
Configuration
of safety input
SAFE 2
SAFE 2.
74
Configuration
of command
IC 1
input IC 1.
61
Configuration
of command
IC 2
input IC 2.
62
Configuration
of AUX 0 ou-
AUX 0
tput. 20-21
Configura-
tion of AUX 3
AUX 3
output.
26-37
Fixed code
FIXED CODE
INSTALLATION MANUAL
Cross
out
Default
setting
used
0 Input configured as Phot (photocell).
1 Input configured as Phot test (tested photocell).
0
2 Input configured as Phot op (photocell active during opening only).
3 Input configured as Phot op test (tested photocell active during opening only).
4 Input configured as Phot cl (photocell active during closing only).
5 Input configured as Phot cl test (tested photocell active during closing only).
6 Input configured as Bar, safety edge.
7 Input configured as Bar, tested safety edge.
8 Input configured as Bar 8k2.
*
Input configured as Bar OP, safety edge with inversion active only while opening. If while closing, the movement stops.
9
6
Input configured as Bar OP TEST, safety edge tested with inversion active only while opening. If while closing, the
*
10
movement stops.
Input configured as Bar OP 8k2, safety edge with inversion active only while opening. If while closing, the move-
*
11
ment stops.
*
Input configured as Bar CL, safety edge with inversion active only while closing. If while opening, the movement stops.
12
Input configured as Bar CL TEST, safety edge tested with inversion active only while closing. If while opening, the
*
13
movement stops.
Input configured as Bar CL 8k2, safety edge with inversion active only while closing. If while opening, the move-
*
14
ment stops.
0 Input configured as Start E.
1 Input configured as Start I.
0
2 Input configured as Open.
3 Input configured as Close.
4 Input configured as Ped.
4
5 Input configured as Timer.
6 Input configured as Timer Pedestrian.
0 Output configured as 2nd Radio Channel.
1 Output configured as SCA (gate open light).
6
2 Output configured as Courtesy Light command.
3 Output configured as Zone Light command.
4 Output configured as Stair Light
5 Output configured as Alarm
6 Output configured as Flashing light
7 Output configured as Latch
0
8 Output configured as Magnetic lock
9 Output configured as Maintenance
10 Output configured as Flashing Light and Maintenance.
Receiver is configured for operation in rolling-code mode.
0
Fixed-Code Clones are not accepted.
0
Receiver is configured for operation in fixed-code mode.
1
Fixed-Code Clones are accepted.

Optional extras

DEIMOS ULTRA BT A 400 - DEIMOS ULTRA BT A 600 -
41