Special Functions - ALLURIS FMI-100 Notice D'utilisation

Data length
Stop bit
Parity
7.3.2. Protocol codes
A table with the protocol codes for communication between measurement instrument and external data
processor is available at www.alluris.de .
7.4. USB Interface, only FMI-220 and FMI-230
Before connecting the force gauge via USB-interface to a PC in order to transfer data, please install the
optionally available software (order no.: FMI-972 USB). By that, you may transfer measurement results and
memorised values to Microsoft Exel and continue to process them.
Please do not leave the USB-cable connected to the force gauge for long. Even if it is switched off the
instrument may dissipate energy.
7.5 Software
We offer suitable software for transferring
the data to standard
applications. The
Fmi_Connect (Part No. FMI-972), for
example, is an Add-In for MS Excel, which
allows to write the captured data directly
into your computer.

8.0 Special functions

8.1. Reversing the display (Default: upright)
8 bits
1
None
Microsoft
easy-to-use
Reversing the display is recommended when the gauge is being used for tensile force
measurements or in a vertical test stand. Please proceed as follows:
•
Switch instrument off.
•
Press and hold MODE-button.
•
Keep MODE-button pressed while switching instrument on with I/0-button.
•
Wait until the Display is reversed, then release MODE-button.
You may return to the original setting by using the same buttons.
FMI-200 | FMI-210 | FMI-400
28
FMI-100 | FMI-300
FMI-220 | FMI-230