ALLURIS FMI-100 Notice D'utilisation page 31

9.0 Application with test stands
The rugged aluminium dye cast housing of the force gauges enables applications on a test stand. 4 tap holes at
the rear of the housing can take up fixing screws with metrical threads.
For a force gauge, both manual and motorized test-stands are sound supplements, which linear strokes for
tensile and compressive force measurements can be conducted with. Thus, the stability of material
compounds, the operating force of control elements, or the adhesive force of packagings and films can be
detected accurately and reproducible. We are pleased to be at your command for custom-designed advices. In
the internet, at www.alluris.de, you will find product information about our test-stands.
FMI-200 | FMI-210 | FMI-400
The length of the screws should not exceed the
tape hole depth. Improper fastening (e.g. too
long screws) can distort the housing and lead
to inaccurate measuring results or damages.
Included in the scope of supply is a hanger,
which can be attached and fastened with a
Phillips screw to the rear of the instrument.
Moreover, in odrer to achieve accurate and
reproducible results, the forces should always
be applied perpendicular to the measuring axle
when the gauge is mounted on a test stand.
Dimensional
instruments to a test-stand can be found at
www.alluris.de.
31
FMI-100 | FMI-300
FMI-220 |
The fixings for the handles at
the side of the FMI-300/400
series` instruments
designed for
maximum.
drawings for mounting
is
2500N
the