ALLURIS FMI-100 Notice D'utilisation page 25

6.2. Setting the memory mode of operation
•
Switch instrument off.
•
Press and hold the PEAK- and the MEM-button.
•
Press the On/Off-button.
•
Wait until HI is displayed, then release the PEAK- and the MEM-button.
•
Select the function MEM with the PEAK-button.
•
Then, choose the desired mode of memory with the MODE-button.
•
Save the setting by pressing the »O«-button.
6.3. Standard memory (Std)
6.3.1. Recording measurement sequences
In order to save the results of a measurement series, please proceed as follows:
•
Switch instrument off.
•
Press the MEM-button before conducting the measurement. A blinking "M" will appear on the
display.
•
Undertake the measurement.
•
After done measurement, press again the MEM-button. The values of this measurement will be
stored.
Each time, the maximum and minimum value of compressive and tensile force, the Peak value (+/-) and the last
measured value in the 1000Hz mode are considered. Altogether, the instrument can store 50 measurement
sequences.
6.3.2. Recalling stored values
In order to read the stored values, please proceed as follows:
•
Switch instrument off.
•
Press and hold the MEM-button.
•
Operate the On/Off-button.
•
Wait until Std is displayed; then, release the MEM-button.
•
The number of the last measurement sequence is blinking by turns with the corresponding
measurement value.
•
You get to the maximum value etc by pressing the MODE-button.
•
You get to the timely earlier measured values with a lower reference number by pressing the MEM-
button.
First of all, the last captured value is displayed. After that, this value`s maximum and minimum value (+/-) and
its Peak value (+/-) will be shown rotationally.
6.3.3. Deleting stored values
In order to delete the results of the last measurement series, or to empty the entire storage, please proceed as
follows:
•
Switch off instrument.
•
Press and hold the MEM-button.
•
Operate the On/Off-button.
•
Wait until Std is displayed.
•
Then, release the MEM-button.
•
Do not release button 3 until Std has appeared above on the display.
•
The last measurement series with the highest reference number can be deleted by shortly pressing
the »O«-button once. The entire storage of measured values will be deleted when keeping the »O«-
button pressed until "nonE" appears on the display (approx. 5sec).
6.4. Single value memory (SinG)
6.4.1. Recording single measured values
Every measured value, which is visible on the display, is stored when pressing the MEM-button. This, for
example, can also be a PEAK value that is shown on the display after a measurement. The symbol M is shown
for a short moment on the display.
25