Publicité
Les langues disponibles
Les langues disponibles
LIGHTING G S BURNERS
Models without safety valve device
To light one of the gas burners, push in
and turn the relative knob to the maxi-
mum aperture position (large flame
symbol
fig. 2.1a) and hold the knob
in until the flame has been lit.
In case of black-out, bring a lighted
match close to the burner.
Turn the gas tap to the position
required.
Note: Whenever special conditions of
the gas supplied locally make it difficult
to light the burner with the knob in the
maximum flow position, repeat the
operation with the knob in the minimum
flow position.
Fig. 2.2
LIGHTING G S BURNERS
Models with safety valve device
In order to light the burner, you must:
1 – Turn the knob fig. 2.2 in anti-clock-
wise direction up to the maximum
aperture (symbol
in and hold the knob; this will light
the gas. In case of black-out, bring
a lighted match close to the burner.
2 – Wait about ten seconds after the
gas lighting before releasing the
knob (starting time for the valve).
3 – Adjust the gas valve to the desired
power.
If the burner flame should go out for
some reason, the safety valve will auto-
matically stop the gas flow.
To re-light the burner, return the knob to
G
the closed
position, wait for at least
1 minute and then repeat the lighting
procedure.
If your local gas supply makes it difficult
to light the burner with the knob set to
maximum, set the knob to minimum and
repeat the operation.
The ignition device shall not be
operated for more than 15 seconds.
If after 15 seconds the burner has
not lit, stop operating the device
and open the compartment door of
the cabinet underneath (if available)
and/or wait at least 1 minute before
attempting a further ignition of the
burner.
fig. 2.1b ) , push
9
Publicité
