Télécharger Imprimer la page

Elba E74-200 Série Mode D'emploi page 24

Publicité

Les langues disponibles

Les langues disponibles

DDITION L G S CONNECTION REQUIREMENTS
When connecting the cooktop to the gas supply with a rubber hose, make sure that:
If not already fitted, you fit the Natural gas or LPG hose holder on the inlet pipe, mak-
ing sure that you place the sealing washer between them (as shown in Fig. 6.1). If the
hose holder is not supplied with the appliance it can be purchased by contacting the
After-Sales Service.
You connect the cooktop to the gas supply using a suitable rubber hose (internal
diameter 15 mm for Natural gas or internal diameter 6 mm for LPG). The hose must
comply with the applicable local regulations and be of the correct construction for the
type of gas being used.
You make sure that the hose is tightly and securely fitted at both ends.
You use a standard hose clamp (not supplied) to fasten the hose.
The hose is as short as possible, without twists or kinks.
The hose is not longer than 750 mm (or refer to applicable local regulations) and does
not come into contact with sharp edges, corners or moving parts.
The hose is not under tension, twisted, kinked or too sharply bent.
The hose does not come into contact with any part of the cooktop with a surface tem-
perature of 70°C or above
The hose can easily be inspected along its entire length to check its condition.
The hose is replaced at the printed due date or if it shows signs of wear or damage,
and replaced regardless of its condition after a maximum of three years.
You inform the customer that the hose should not be subjected to corrosion by acidic
cleaning agents.
When connecting the cooktop to the gas supply with rigid pipes or a flexible hose,
make sure that:
You use rigid pipes or a flexible hose compliant with applicable local regulations. The
flexible hose shall be of the correct construction for the type of gas being used and of
the correct size to maintain the heat output of the appliance.
The connection with rigid metal pipes does not cause stress or pressure to the gas piping.
The flexible hose is not under tension, twisted, kinked, or too tightly bent, neither
while the cooktop is in use nor while it is being connected or disconnected.
The flexible hose is not longer than 2000 mm (or refer to applicable local regulations)
and does not come into contact with sharp edges, corners, or moving parts, as these
may cause abrasion. Use a single flexible hose only; never connect the cooktop with
more than one flexible hose.
The flexible hose can easily be inspected along its entire length to check its condition;
if it has an expiry date, it should be replaced before that date.
If using a flexible hose which is not entirely made of metal, make sure that it does not
come into contact with any part of the cooktop with a surface temperature of 70°C or
above (or refer to applicable local regulations).
The rigid pipe or flexible hose is replaced if it shows signs of damage.
The flexible hose is not subject to excessive heat by direct exposure to flue products
or by contact with hot surfaces.
The socket into which the plug of the flexible hose fit is permanently attached to a firmly
fixed gas installation pipe and is positioned so that the hose hangs freely downwards.
The plug of the flexible hose is accessible after installation, so that it can be discon-
nected for service or removal.
You inform the customer that the rigid pipe or flexible hose should not be subjected
to corrosion by cleaning agents.
24
(or refer to applicable local regulations).

Publicité

loading

Ce manuel est également adapté pour:

E74-201 série