Publicité
Les langues disponibles
Les langues disponibles
Clearance
Cupboard
door
Space for
connections
C
Fig. 5.4
C
Fig. 5.5
Fig. 5.3
D
A
B
D
A
B
CUPBO RD DOORS
It is recommended that a 30 mm clear-
ance be left between the hob and the
partition surface underneath.
F STENING THE COOKTOP
(fig. 5.4 - 5.5)
Each hob is supplied with a set of tabs
and screws to fasten it on units with a
worktop 3 to 4 cm deep.
The kit includes 4 tabs "A" and 4 self-
tapping screws "B".
Cut the unit.
Stretch gasket "D" over the edge of
the hole made, being careful to over-
lay the junction edges
Turn the hob over and put tabs "A"
(fig. 5.4 - 5.5) into the housings, only
tighten screws "B" a few turns.
Make sure that the tabs are mounted
correctly as shown in the figure 5.4 -
5.5. Turn the tabs so that the cooktop
can be dropped into the aperture.
Lay the hob into the aperture of the
unit and position it correctly.
Put tabs "A"; into place, tooth "C" of
the tabs should go into the hole.
Tighten screws "B" until the hob is
completely secured.
Using a sharp tool cut off the part of
gasket "D" which protrudes from the
cooktop. Take care not to damage the
benchtop.
(fig. 5.3)
19
Publicité
