Publicité
Les langues disponibles
Les langues disponibles
Accessory: Microphone cable with
2.5 mm jack plug
Congratulations on purchasing your
Radio Telephone Transmitter - Acou-
stic. We hope it will give you many
years of reassuring operation.
Please read through these operating
instructions carefully. They tell you
how to set up the system correctly
and explain all the system's features
to you.
Functional principle
A signalling system consists of at
least one transmitter and one recei-
ver. The Radio Telephone Transmit-
ter - Acoustic uses a microphone to
pick up the signals from the telepho-
ne. It converts these signals into
radio pulses (868.35 MHz) and trans-
mits them to the receiver without
the need for wires.
Special features
When a signal is detected, it is
transmitted for a total of 22
seconds. This increases both the
reliability and the range of the
system.
Included in the standard
package:
- lisa Radio Telephone Transmitter-
Acoustic
- Microphone cable, length 1 m
- Stand
- 9 V block battery
- Operating Instructions
- Warranty card
If any parts are missing please
immediately contact your dealer
or the manufacturer directly.
Setting up the system –
1. Inserting the battery
There is a battery compartment on
the back of the Radio Telephone
Transmitter. Open it by sliding the
cover of the battery compartment to
the right of the receiver using your
thumb. Connect a 9 V block battery
to the connector plug, place the bat-
tery into the recess and close the
receiver again. When the battery is
connected, the receiving signals may
be triggered once.
English 9
Publicité
