Textron Ransomes Frontline 728 Série Manuel De Maintenance page 14

MAINTENANCE
ENGINE OIL
See Engine Manual for manfacturer's
recommendations. Before using the machine for
the first time, check the oil level in the engine
crankcase with the crankcase dipstick. When
checking oil level, make sure the machine is on
level ground.
To change engine oil:
1. First warm up the engine. Shut off engine when
warm, remove oil drain plug P and drain the oil
from the sump.
2. Clean plug and replace.
3. Re-fill sump with the recommended engine oil.
4. Always check level of oil on the dipstick. To
obtain the correct measurement, the machine
should be on level ground.
NOTE: After the oil has been added, wait one
minute and then check level of oil again with the
dipstick.
To change engine oil filter:
The oil filter cartridge O is easily reached from the
right side of the tractor. It should be replaced
complete with each oil change. Apply a thin film of
oil to the seal when replacing the cartridge and
check for leaks after starting the engine. Top off oil
if necessary.
AIR CLEANER
Clean and replace the air cleaner element as
specified in the service chart. Uneven running, lack
of power or black exhaust fumes may indicate a
dirty air cleaner.
To replacing air cleaner element:
1. Unclamp end cover and remove existing
cleaner element Y.
2. Insert new element Z and replace end cover.
Ensure arrows on end cover are pointing
vertically upwards.
GB-12
RANSOMES 700 Series EC Tractors
SETUP PARTS & MAINTENANCE MANUAL